Partial list of this Kenmore Top Load Washer components
(for additional details, please see All Parts & Diagrams
Top and cabinet parts section contains screw, lid hinge mounting (4) dispenser, bleach clip, top & cabinet & rear panel (2) lid hinge, lid (l.h.) screw, ground spacer, cabinet to top use & care guide screw, 10-16 x 3/8 (4) switch, lid. Control panel parts section includes screw, ground knob, selection switch, rotary cap, end (l.h.) (includes item 8) assembly, timer skirt switch, pressure screw, timer mounting harness, wiring bracket, control panel, console. Rear panel parts parts include clip, harness & pressure hose cable tie clamp, hose cord, power (includes item 8) screw, strap to panel (8-18 x 3/8) hose, water inlet (hose (inlet), red) drain hose assembly (includes items 2 & 17) clip, capacitor clamp, hose clamp, hose. Agitator, basket and tub parts components are gasket, centerpost spring compression washer tub washer, agitator block, basket drive auger, agitator retainer, spring screw & washer dog, agitator clutch (4). Brake, clutch, gearcase, motor and pump parts section contains ring, retainer screw, 10-16 x 5/8 shield, motor screw clip, anti-rattle switch, main drive motor spring & damper assembly motor, main drive retainer, pump (2) seal. Machine base parts section includes ring, sound deadening pad, plate foot, front (2) screw, bracket mounting (10-32 x 5/8) retainer, suspension spring (3) bracket, spring outer (2) spring, counterweight seal, centerpost foot, rear (2) bearing, centerpost (2). Wiring harness parts section includes clip, harness block, disconnect (motor 2 speed) block, disconnect (12-way) protector block, disconnect timer, block disconnect (natural) connector (t.p.a.) (3-circuit) plug, terminal (3-way) plug (t.p.a) (3-circuit) (pressure switch) clip, harness (push-in). Brake and drive tube parts parts include lubricant (use only in brake shoe assembly on roller & pin) driver, brake cam sleeve, brake spring cam, brake release ring, thrust cap, brake spring (2) tube, basket drive (includes illus. 3, 4, 5 & 9) sleeve, cam ring, retaining ring, retaining. Gearcase parts, optional parts (not included) parts include inlet hoses, 5 ft. (two braided hoses w/straight ends & 4 rubber washers) paint, pressurized spray (12 oz.) (white) spring, agitate sealer, gasket (.20 fl. oz.) (6 ml) ring, retaining gear, spin gear, agitate (includes 15 and 29) cam, agitate (includes 13) inlet hoses, 5 ft. (one red hose & one blue hose w/straight ends & 4 rubber washers) drain hose adapter kit.